Preference (Ipv6 Mbgp Address Family View) - HP 3600 v2 Series Command Reference Manual

Description
Use peer route-policy to apply a routing policy to routes incoming from or outgoing to an IPv6 MBGP
peer or peer group.
Use undo peer route-policy to remove the configuration.
By default, no routing policy is applied to the routes incoming from or outgoing to an IPv6 MBGP peer
or peer group.
The if-match interface clause in the routing policy referenced by the peer route-policy command is not
applied.
For more information, see Layer 3—IP Routing Command Reference.
Examples
# Apply the routing policy test-policy to routes received from the IPv6 MBGP peer group test.
<Sysname> system-view
[Sysname] route-policy test-policy permit node 10
[Sysname-route-policy] if-match cost 10
[Sysname-route-policy] apply cost 65535
[Sysname-route-policy] quit
[Sysname] bgp 100
[Sysname-bgp] ipv6-family
[Sysname-bgp-af-ipv6] group test external
[Sysname-bgp-af-ipv6] quit
[Sysname-bgp] ipv6-family multicast
[Sysname-bgp-af-ipv6-mul] peer test enable
[Sysname-bgp-af-ipv6-mul] peer test route-policy test-policy import

preference (IPv6 MBGP address family view)

Syntax
preference { external-preference internal-preference local-preference | route-policy route-policy-name }
undo preference
View
IPv6 MBGP address family view
Default level
2: System level
Parameters
external-preference: Specifies the preference of IPv6 multicast eBGP routes, in the range of 1 to 255. An
IPv6 multicast eBGP route is learned from an IPv6 multicast eBGP peer.
internal-preference: Specifies the preference of IPv6 multicast iBGP routes, in the range of 1 to 255. An
IPv6 multicast iBGP route is learned from an IPv6 multicast iBGP peer.
local-preference: Specifies the preference of locally generated IPv6 MBGP routes, in the range of 1 to
255.
451