Igmp-Snooping Static-Router-Port - HP 3600 v2 Series Command Reference Manual

Parameters
group-address: Specifies the address of the multicast group that the port joins as a static member port, in
the range of 224.0.1.0 to 239.255.255.255.
source-address: Specifies the address of the multicast source that the port joins as a static member port.
The value of this argument should be a valid unicast address or 0.0.0.0. A source IP address of 0.0.0.0
means no restriction on the multicast source.
vlan vlan-id: Specifies the VLAN that comprises the ports, where vlan-id is in the range of 1 to 4094.
Description
Use igmp-snooping static-group to configure the static (*, G) or (S, G) entry for the port, namely, to
configure the port as a static member port of the specified multicast group or source-group.
Use undo igmp-snooping static-group to restore the default.
By default, no ports are static member ports.
The source-ip source-address option in the command is meaningful only for IGMPv3 snooping. If
IGMPv2 snooping is running, the source-ip source-address option does not take effect although you can
include source-ip source-address in the command.
In Layer 2 Ethernet interface view or Layer 2 aggregate interface view, this command takes effect only if
the interface belongs to the specified VLAN.
In port group view, this command takes effect only on those ports in this port group that belong to the
specified VLAN.
Examples
# Configure Ethernet 1/0/1 in VLAN 2 to be a static member port for (1.1.1.1, 232.1.1.1).
<Sysname> system-view
[Sysname] igmp-snooping
[Sysname-igmp-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] igmp-snooping enable
[Sysname-vlan2] igmp-snooping version 3
[Sysname-vlan2] quit
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] igmp-snooping static-group 232.1.1.1 source-ip 1.1.1.1 vlan 2

igmp-snooping static-router-port

Syntax
igmp-snooping static-router-port vlan vlan-id
undo igmp-snooping static-router-port vlan vlan-id
View
Layer 2 Ethernet interface view, Layer 2 aggregate interface view, port group view
Default level
2: System level
Parameters
vlan vlan-id: Specifies a VLAN, where vlan-id is in the range of 1 to 4094.
30