Mld-Snooping Done Source-Ip - HP 3600 v2 Series Command Reference Manual

Ip multicast
Hide thumbs Also See for 3600 v2 Series:
Table of Contents

Advertisement

Default level
2: System level
Parameters
acl6-number: Specifies a basic or advanced IPv6 ACL number, in the range of 2000 to 3999. The source
address or address range specified in the advanced ACL matches the multicast source address or
addresses specified in MLDv2 reports, rather than the source address in the IP packets. The system
assumes that an MLDv1 report or an MLDv2 IS_EX and TO_EX report that does not carry an IPv6
multicast source address carries an IPv6 multicast source address of 0::0.
all: Specifies all IPv6 ACLs.
Description
Use mld-snooping access-policy to configure an IPv6 multicast user control policy.
Use undo mld-snooping access-policy to remove the configuration.
By default, no IPv6 user control policy is configured. Namely, a user can join any valid IPv6 multicast
group.
You can use this command repeatedly to configure multiple IPv6 multicast user control policies.
Examples
# Create and enable a user profile named abc, and configure the user profile so that users in this user
profile can join FF03::101 only.
<Sysname> system-view
[Sysname] acl ipv6 number 2001
[Sysname-acl6-basic-2001] rule permit source ff03::101 16
[Sysname-acl6-basic-2001] quit
[Sysname] user-profile abc
[Sysname-user-profile-abc] mld-snooping access-policy 2001
[Sysname-user-profile-abc] quit
[Sysname] user-profile abc enable

mld-snooping done source-ip

Syntax
mld-snooping done source-ip { ipv6-address | current-interface }
undo mld-snooping done source-ip
View
VLAN view
Default level
2: System level
Parameters
ipv6-address: Specifies a source IPv6 address for the MLD done messages that the MLD snooping proxy
sends, which can be any legal IPv6 link-local address.
current-interface: Specifies the IPv6 link-local address of the current VLAN interface as the source
address of MLD done messages that the MLD snooping proxy sends. If no IPv6 address has been
assigned to the current interface, the default IPv6 address FE80::02FF:FFFF:FE00:0001 is used.
264

Advertisement

Table of Contents
loading

Table of Contents