Mld-Snooping Version - HP 3600 v2 Series Command Reference Manual

Parameters
vlan vlan-id: Specifies a VLAN by its ID, in the range of 1 to 4094.
Description
Use mld-snooping static-router-port to configure the current port as a static router port.
Use undo mld-snooping static-router-port to restore the default.
By default, no ports are static router ports.
For the HP 3600 v2 EI switches, this command takes effect in both MLD snooping-enabled VLANs and
VLANs with MLD enabled on their VLAN interfaces.
For the HP 3600 v2 SI switches, this command takes effect in MLD snooping-enabled VLANs.
This command does not take effect in a sub-VLAN of an IPv6 multicast VLAN.
In Layer 2 Ethernet interface view or Layer 2 aggregate interface view, this command takes effect only if
the interface belongs to the specified VLAN. In port group view, this command takes effect only on those
ports in this port group that belong to the specified VLAN.
Related commands: subvlan.
Examples
# Enable the static router port function on Ethernet 1/0/1 in VLAN 2.
<Sysname> system-view
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] mld-snooping static-router-port vlan 2

mld-snooping version

Syntax
mld-snooping version version-number
undo mld-snooping version
View
VLAN view
Default level
2: System level
Parameters
version-number: Specifies an MLD snooping version. The value can be 1 or 2.
Description
Use mld-snooping version to configure the MLD snooping version.
Use undo mld-snooping version to restore the default.
By default, the MLDv1 snooping is used.
This command can take effect only if MLD snooping is enabled for the VLAN, and it does not take effect
in a sub-VLAN of an IPv6 multicast VLAN.
Related commands: mld-snooping enable and subvlan.
283