Connectors - Teledyne G3-GM10-M0641 User Manual

The factory defaults for Nano is Persistent IP disabled and DHCP enabled with LLA always
•
enabled as per the GigE Vision specification. For additional information see Nano IP
Configuration Mode Details. See the next section Connectors for an overview of the Nano
interfaces.

Connectors

The Nano has two connectors:
A single RJ45 Ethernet connector for control and video data transmitted to/from the host
•
computer Gigabit NIC. The Genie Nano also supports
See Ruggedized RJ45 Ethernet Cables for secure cables.
A 10 pin I/O connector for camera power, plus trigger, strobe and general I/O signals. The
•
connector supports a retention latch, while the Nano case supports thumbscrews. Teledyne
DALSA provides optional cables (see Accessories). See 10-pin I/O Connector Details for
connector pin out specifications.
Note that the NanoXL uses the same two connectors but on a larger camera body.
•
The following figure of the Genie Nano back end shows connector and LED locations. See
Mechanical Specifications for details on the connectors and camera mounting dimensions, including
the NanoXL.
Status LED
10 Pin
I/O & Power
Ethernet Connector
(supports PoE)
Supports
Thumbscrew
Secured Cables
•
76 Connecting the Genie Nano Camera
Power over Ethernet
Genie Nano – Rear View
(PoE).
Camera Mounts
(4 sides)
Optional Tripod
Mount
Nano Series GigE Vision Camera