Firmware Files For 1920, 1940 - Teledyne G3-GM10-M0641 User Manual

Binning Support
Decimation Support
Defective Pixel Replacement
Image Correction
Image Flip Support
Multi-ROI Support
On-Board Image Memory
Output Dynamic Range (dB)
SNR (dB)
Notes:
* Entire Resolution includes Over-scan pixels:
Active resolution is 1920 x 1200. The 8 + 8 additional pixels per line and 8 + 8 additional
•
vertical lines are available for preprocessing and/or camera mechanical alignment
operations in a system.
** Limited to the Genie Nano Architecture:
~250MB/sec Sustained into the TurboDrive Engine
•
Additional note: This transfer was achieved using 1500 Byte Packet Size.
•
*** Actual Exposure Time:
The actual internal minimum exposure may be different than what is programmed. Use the
•
feature "exposureTimeActual" from the
sensor exposure.

Firmware Files for 1920, 1940

The latest firmware files for all Nano models are available on the Teledyne DALSA support web site:
http://www.teledynedalsa.com/imaging/support/downloads/firmware/
The firmware files for these models are listed below. The xx denotes the current build number.
M1920
Standard
•
"Genie_Nano_Sony_IMX249-2M_Mono_STD_Firmware_3CA18.xx.cbf"
C1920
Bayer Output
•
"Genie_Nano_Sony_IMX249-2M_Bayer_STD_Firmware_4CA18.xx.cbf"
• RGB Output
"Genie_Nano_Sony_IMX249-2M_RGB_Output_Firmware_4CA18.xx.cbf"
M1940
Standard
•
"Genie_Nano_Sony_IMX174-2M_Mono_STD_Firmware_1CA18.xx.cbf"
C1940
Bayer Output
•
"Genie_Nano_Sony_IMX174-2M_Bayer_STD_Firmware_2CA18.xx.cbf"
• RGB Output
"Genie_Nano_Sony_IMX174-2M_RGB_Output_Firmware_4CA18.xx.cbf"
•
26 Genie Nano Specifications
Yes In-FPGA
(summing and average)
2x2, 4x4
Yes, In-Sensor, Vertical and Horizontal
Yes, in-sensor, up to 16 ROI (mutually exclusive with binning)
68.3 dB (in 10-Bit Pixel Format)
43.9 dB (in 10-Bit Pixel Format)
Sensor Control
No
No
No
No
90MB
category to read back the actual
Nano Series GigE Vision Camera