Firmware Files For Models 1280, 1930, 2590 - Teledyne G3-GM10-M0641 User Manual

Gain Control
Binning Support
Decimation Support
Defective Pixel Replacement
Image Correction
Image Flip Support
Multi-ROI Support
On-Board Image Memory
Output Dynamic Range (dB)
SNR (dB)
* Note: The actual internal minimum exposure may be different than what is programmed. Use the feature
"exposureTimeActual" from the
event is delayed 4 µs from the actual start.

Firmware Files for Models 1280, 1930, 2590

The latest firmware files for all Nano models are available on the Teledyne DALSA support web site:
http://www.teledynedalsa.com/imaging/support/downloads/firmware/
The firmware files for these models are listed below. The xx denotes the current build number.
M1280, M1930, M2590
Standard
•
"Genie_Nano_OnSemi_Python_0.3M-0.5M-1.3M-2M-5M_Mono_STD_Firmware_5CA18.xx.cbf"
C1280, C1930, C2590
• Bayer Output
"Genie_Nano_OnSemi_Python_0.3M-0.5M-1.3M-2M-5M_Bayer_STD_Firmware_6CA18.xx.cbf"
• RGB Output
"Genie_Nano_OnSemi_Python_0.3M-0.5M-1.3M-2M-5M_RGB_Output_Firmware_6CA18.xx.cbf"
Nano Series GigE Vision Camera
In-sensor Analog Gain (1.0x to 8x) in 11 gain steps
(1.0, 1.14, 1.33, 1.6, 2.0, 2.29, 2.67, 3.2, 4.0, 5.33, 8.0)
In-sensor Digital Gain (1x to 32x) in 0.01x steps
Yes In-FPGA
(summing and average,
2x2, 4x4 )
Yes In- Sensor
(averaging 2x2)
Yes, in Sensor, up to 16 ROI (mutually exclusive with binning)
Sensor Control category to read back the actual sensor exposure. The exposure start sensor
In-FPGA Digital Gain (1x to 4x) in 0.007x steps
No
Yes, up to 512 positions
No
Yes, In-Sensor, Vertical Only
90MB
62.1 dB (in 10-Bit Pixel Format)
39.8 dB (in 10-Bit Pixel Format)
Genie Nano Specifications
No
•
61