Event Control Feature Descriptions - Teledyne G3-GM10-M0641 User Manual

Event Control Feature Descriptions

The following table describes these parameters along with their view attribute and minimum
camera firmware version required. Additionally the Device Version column will indicate which
parameter is a member of the DALSA Features Naming Convention (denoted by DFNC), versus the
GenICam Standard Features Naming Convention (SFNC tag is not shown).
The Device Version number represents the camera software functional group, not a firmware
revision number. As Genie Nano capabilities evolve the device version tag will increase, therefore
identifying the supported function package. New features for a major device version release will be
indicated by green text
Display Name
Timestamp Latch Cmd
Timestamp Value
TimeStamp Source
Internal Clock
IEEE1588
Timestamp Tick Frequency
Timestamp Latch Source
Frame Start
Timestamp Reset Cmd
Event Selector
Start of Frame
Start of Exposure
End of Exposure
Start of Readout
End of Readout
Acquisition Start Next
Valid
Valid Frame Trigger
Nano Series GigE Vision Camera
for easy identification.
Feature & Values
timestampControlLatch
timestampValue
timestampSource
InternalClock
IEEE1588
timestampTickFrequency
timestampLatchSource
FrameStart
timestampControlReset
EventSelector
FrameStart
ExposureStart
ExposureEnd
ReadoutStart
ReadoutEnd
AcquisitionStartNextValid
ValidFrameTrigger
Description
Latch the current timestamp internal counter value
in the timestampValue feature.
Returns the 64-bit value of the timestamp, which
is the internal Clock timer or the PTP clock timer,
depending on the Timestamp Source selection.
Specifies the source used as the incrementing
signal for the Timestamp register.
The timestamp source is generated by the camera
internal clock. Refer to the
timestampTickFrequency feature for the time
base.
The timestamp source is controlled by the network
IEEE1588 protocol. This source is automatically
selected when PTP mode is enabled.
Indicates the number of timestamp ticks (or
increments) during 1 second (frequency in Hz).
This feature changes depending on the TimeStamp
Source.
Specifies the internal event or signal that will latch
the timestamp counter into the timestamp buffer.
The timestamp is latched on frame start.
Resets the timestamp counter to 0. This Feature
resets both the internal Clock timer and the PTP
clock timer. Note that the PTP Mode must be
disabled first to reset the PTP clock timer.
Select the Event to enable/disable with the
EventNotification feature.
Event sent on control channel on an Active Frame.
This occurs with the start of the exposure delay.
Event sent on control channel on start of
exposure.
Event sent on control channel on end of exposure.
(N/A for C4900 – 1.06)
Event sent on control channel on start of sensor
readout.
Event sent on control channel on end of sensor
readout.
Event sent on control channel when the
AcquisitionStart command can be used again.
Event sent on control channel when a valid frame
trigger is generated.
Operational Reference
Device
Version
& View
1.00
Expert
DFNC
1.00
Expert
DFNC
1.00
Expert
DFNC
1.00
Expert
DFNC
1.00
Expert
DFNC
1.00
Expert
DFNC
1.00
Expert
•
185