Firmware Files For Model M2050 - Teledyne G3-GM10-M0641 User Manual

Trigger to Exposure Start jitter
(Reset Exposure Alignment)
Actual Exposure Time Minimum
(see "exposureTimeActual"
in Sensor Control)
Min. Time from End of Exposure to
Start of Next Exposure
Horizontal Line Time:
Readout Time
Auto-Brightness
Black offset control
Gain Control
Binning Support
Decimation Support
Defective Pixel Replacement
Image Correction
Image Flip Support
Multi-ROI Support
On-Board Image Memory
Output Dynamic Range (dB)
SNR (dB)
* Limited to the Genie Nano Architecture:
~250MB/sec Sustained into the TurboDrive Engine achieved using 1500 Byte Packet Size

Firmware Files for Model M2050

The latest firmware files for all Nano models are available on the Teledyne DALSA support web site:
http://www.teledynedalsa.com/imaging/support/downloads/firmware/
The firmware files for this model are listed below. The xx denotes the current build number.
M2050
Standard
•
"Genie_Nano_Sony_IMX25x_3.2M-5.1M-9M-12M _Mono_STD_Firmware_7CA18.xx.cbf"
• High Sensitivity
"Genie_Nano_Sony_IMX25x_3.2M-5.1M-9M-12M_Mono_HSD_Firmware_7CA18.xx.cbf"
•
30 Genie Nano Specifications
18.1µs (1 line time + 13.73 us)
(increment of 4.4µs steps)
10 lines–13.73µs
(30.3 µs)
4.4µs
(H Line Time) x (lines in frame +23) — in μs
Yes , with Auto-Exposure and AGC (FPGA Gain or Sensor Gain)
In-sensor Gain (1.0x to 251x)
In-FPGA Digital Gain (1x to 4x) in 0.007x steps
Yes In-FPGA (summing and average)
Yes, In-Sensor, Vertical and Horizontal
Yes, In-Sensor, up to 16 ROI (mutually exclusive with in-sensor binning)
56.7
33.01
0 µs
19.1µs (1 line time + 13.73 us)
(increment of 5.4µs steps)
10 lines–13.73µs
(40.4 µs)
5.4µs
Yes (in DN)
2x2, 4x4
No
No
No
90MB
75.4 dB (in 8-Bit Pixel Format)
39.6 dB (in 8-Bit Pixel Format)
Nano Series GigE Vision Camera