Action Control Feature Descriptions; Gige Vision Action Command Reference; Nano Features Supporting Action Command - Teledyne G3-GM10-M0641 User Manual

Action Control Feature Descriptions

The following table describes these parameters along with their view attribute and minimum
camera device version required. Additionally the Device Version column will indicate which
parameter is a member of the DALSA Features Naming Convention (denoted by DFNC), versus the
GenICam Standard Features Naming Convention (SFNC tag is not shown).
The Device Version number represents the camera software functional group, not a firmware
revision number. As Genie Nano capabilities evolve the device version tag will increase, therefore
identifying the supported function package. New features for a major device version release will be
indicated by green text
Display Name
Action Device Key
Action Selector
Action Group Key
Action Group Mask

GigE Vision Action Command Reference

An Action Command is a single Broadcast packet sent from the Host Software application to all
cameras connected on the same network. How cameras act on an Action Command depends on its
designed feature support. Cameras receiving the Action Command broadcast may have one or
multiple functions acting on that received command.
Please refer to the GigE Vision® Specification — version 2.0 RC6, for configuration and usage
details. Contact Teledyne DALSA Support

Nano Features supporting Action Command

Feature Category
I/O Control
Counter and Timer Control
Nano Series GigE Vision Camera
for easy identification.
Feature & Values
ActionDeviceKey
ActionSelector
ActionGroupKey
ActionGroupMask
Feature
Trigger Selector
Trigger Source
Output Line Source
Counter Start Source
Timer Start Source
Description
Nano default=1
Writing 0 will disable action command.
Provides the device key that allows the device to
check the validity of action commands. (WO)
Selects the action command to configure. Certain
Nano features support 2 Action commands.
Nano default=0 for all action command.
Provides the key that the device uses to validate that
the action command message is part of the requested
group.
Nano default=1 for action 1, or 2 for action 2.
Provides the mask used to filter particular action
command messages for the selected action.
and request example code for Action Command usage.
Enum
Single Frame Trigger (Start)
MultiFrame Trigger (Start)
Action 1
Pulse On: Action 1
Pulse On: Action 2
Action 1
Action 2
Action 1
Action 2
Device Version
Operational Reference
& View
1.03
Guru
1.03
Beginner
1.03
Guru
1.03
Guru
•
183