Display Lacp System-Id - HP 3100 v2 Series Command Reference Manual

Table 14 Command output
Field
Bridge-Aggregation1 current state
Unknown-speed mode,
unknown-duplex mode
PVID
Last clearing of counters
Last 300 seconds input/output
Input/Output (total)
Input/Output (normal)
The brief information of
interface(s) under bridge mode
Link: ADM - administratively
down; Stby - standby
Speed or Duplex: (a)/A - auto; H -
half; F - full
Type: A - access; T - trunk; H -
hybrid
Interface
Link
Speed

display lacp system-id

Syntax
display lacp system-id [ | { begin | exclude | include } regular-expression ]
View
Any view
Default level
1: Monitor level
Description
The Layer 2 interface status:
•
DOWN ( Administratively )—The interface is administratively
shut down with the shutdown command.
•
DOWN—The interface is administratively up but physically down
(possibly because no physical link is present or the link is faulty).
•
UP—The Ethernet interface is both administratively and
physically up.
The interface speed and duplex mode are unknown.
Port default VLAN ID (PVID).
Time when the reset counters interface command was last used to
clear the interface statistics.
Never indicates the reset counters interface command has never
been used on the interface since the device's startup.
Average input/output rate over the last 300 seconds.
Statistics of all packets received/sent on the interface.
Statistics of all normal packets received/sent on the interface.
Brief information about Layer 2 interfaces.
Link status:
•
ADM—The interface has been administratively shut down. To
recover its physical layer state, perform the undo shutdown
command.
•
Stby—The interface is operating as a backup interface.
If the speed of an interface is automatically negotiated, its speed
attribute includes the auto negotiation flag, letter a in parentheses.
If the duplex mode of an interface is automatically negotiated, its
duplex mode attribute includes the auto negotiation flag, letter a in
parentheses or a capital A. Letter H indicates the half duplex mode,
and letter F indicates the full duplex mode.
Link type options for Ethernet interfaces.
Abbreviated interface name.
Physical link state of the interface.
Interface speed, in bps.
66