Jumboframe Enable; Link-Delay - HP 3100 v2 Series Command Reference Manual

[Sysname-Ethernet1/0/1]

jumboframe enable

Syntax
jumboframe enable
undo jumboframe enable
View
System view
Default level
2: System level
Parameters
None
Description
Use the jumboframe enable command to enable jumbo frame support, which allows jumbo frames
within 2048 bytes to pass through all Ethernet interfaces.
Use the undo jumboframe enable command to disable jumbo frame support (prevent frames
longer than 1536 bytes to pass through all Ethernet interfaces).
By default, jumbo frame support is enabled and jumbo frames with 2048 bytes can pass through all
Ethernet interfaces.
Examples
# Enable jumbo frames within 2048 bytes to pass through all Ethernet interfaces.
<Sysname> system-view
[Sysname] jumboframe enable

link-delay

Syntax
link-delay delay-time
undo link-delay
View
Ethernet interface view
Default level
2: System level
Parameters
delay-time: Sets the physical state change suppression interval on the Ethernet interface, ranging
from 2 to 10 seconds.
Description
Use link-delay to set the physical state change suppression interval on an Ethernet interface.
Use undo link-delay to restore the default.
By default, the physical state change suppression interval on an Ethernet interface is 0 seconds.
Do not use this command on Ethernet interfaces with RRPP, MSTP, or Smart Link enabled.
21