Display Lacp System-Id - HP 6125G Command Reference Manual

Table 15 Command output
Field
Bridge-Aggregation1 current state
Unknown-speed mode,
unknown-duplex mode
PVID
Last clearing of counters
Last 300 seconds input/output
Input/Output (total)
Input/Output (normal)
Line protocol current state
Internet protocol processing
The brief information of interface(s)
under bridge mode
Link: ADM - administratively down;
Stby - standby
Speed or Duplex: (a)/A - auto; H -
half; F - full
Type: A - access; T - trunk; H -
hybrid

display lacp system-id

Syntax
display lacp system-id [ | { begin | exclude | include } regular-expression ]
View
Any view
Description
The Layer 2 interface status:
•
DOWN ( Administratively )—The interface is administratively shut
down with the shutdown command.
•
DOWN—The interface is administratively up but physically down
(possibly because no physical link is present or the link is faulty).
•
UP—The Ethernet interface is both administratively and physically up.
The interface speed and duplex mode are unknown.
Port default VLAN ID (PVID).
Time when the reset counters interface command was last used to clear
the interface statistics.
Never indicates the reset counters interface command has never been
used on the interface since the device's startup.
Average input/output rate over the last 300 seconds.
Statistics of all packets received/sent on the interface.
Statistics of all normal packets received/sent on the interface.
Link layer state of the interface.
IP packet processing.
If IP packets cannot be processed, this field displays Disabled.
For an interface configured with an IP address, this field changes to
Internet Address is.
Brief information about Layer 2 interfaces.
Link status:
•
ADM—The interface has been administratively shut down. To recover
its physical layer state, perform the undo shutdown command.
•
Stby—The interface is operating as a backup interface.
If the speed of an interface is automatically negotiated, its speed attribute
includes the auto negotiation flag, letter a in parentheses.
If the duplex mode of an interface is automatically negotiated, its duplex
mode attribute includes the auto negotiation flag, letter a in parentheses
or a capital A. Letter H indicates the half duplex mode, and letter F
indicates the full duplex mode.
Link type options for Ethernet interfaces.
66