HP 3100 v2 Series Command Reference Manual page 19

Eth1/0/9
Eth1/0/10
# Filter the brief interface information to display the line starting with the (s) string and all subsequent
lines.
<Sysname>display interface brief | begin (s)
The brief information of interface(s) under route mode:
Link: ADM - administratively down; Stby - standby
Protocol: (s) - spoofing
Interface
NULL0
RAGG1
Vlan1
Vlan2
# Display the interfaces in down state and the reasons why they are down.
<Sysname> display interface brief down
The brief information of interface(s) under bridge mode:
Link: ADM - administratively down; Stby - standby
Interface
BAGG1
Eth1/0/1
Eth1/0/2
Eth1/0/3
Eth1/0/4
Eth1/0/5
Eth1/0/6
Eth1/0/7
Eth1/0/8
Eth1/0/9
Eth1/0/10
Table 5 Command output
Field
The brief information of
interface(s) under route
mode:
Link: ADM -
administratively down;
Stby - standby
Protocol: (s) - spoofing
Interface
DOWN auto A
DOWN auto A
Link Protocol Main IP
UP UP(s) --
DOWN DOWN --
UP UP 192.168.0.55
DOWN DOWN --
Link Cause
DOWN Not connected
DOWN Not connected
DOWN Not connected
DOWN Not connected
DOWN Not connected
DOWN Not connected
DOWN Not connected
DOWN Not connected
DOWN Not connected
DOWN Not connected
DOWN Not connected
Description
The command displays brief information about Layer 3 interfaces.
Link layer state of the interface:
•
ADM—The interface has been shut down by the network administrator. To
recover its physical layer state, perform the undo shutdown command.
•
Stby—The interface is a standby interface.
If the network layer protocol state of an interface is shown as UP, but its link is
an on-demand link or not present at all, its protocol attribute includes the
spoofing flag (an s in parentheses). This attribute is typical of interface Null 0
and the loopback interfaces.
Interface name.
12
A 1
A 1
Description