Mdi; Multicast-Suppression - HP 3100 v2 Series Command Reference Manual

mdi

Syntax
mdi { across | auto | normal }
undo mdi
View
Ethernet interface view
Default level
2: System level
Parameters
across: Sets the MDI mode to across. In this mode, pins 1 and 2 of the port are receive pins, and
pins 3 and 6 are transmit pins.
auto: Sets the MDI mode to auto. In this mode, the port negotiates pin roles with its peer.
normal: Sets the MDI mode to normal. In normal mode, pins 1 and 2 of the port are transmit pins,
and pins 3 and 6 are receive pins.
Description
Use mdi to configure the MDI mode of a copper Ethernet interface.
Use undo mdi to restore the default.
By default, Ethernet interfaces operate in auto MDI mode.
NOTE:
This command is not applicable to fiber ports.
Examples
# Set Ethernet 1/0/1 to operate in across MDI mode.
<Sysname> system-view
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] mdi across

multicast-suppression

multicast-suppression { ratio | kbps max-kbps }
undo multicast-suppression
View
Ethernet interface view, port group view
Default level
2: System level
Parameters
ratio: Sets the multicast suppression threshold as a percentage of the maximum interface rate,
ranging from 1 to 100. The smaller the percentage, the less multicast traffic is allowed to pass
through.
kbps max-kbps: Specifies the maximum number of kilobits of multicast traffic that the Ethernet
interface can forward per second.
28