Protocol-Vlan - HP 3100 v2 Series Command Reference Manual

Hide thumbs Also See for 3100 v2 Series:
Table of Contents

Advertisement

The configuration made in Layer 2 aggregate interface view applies to the aggregate interface and
its aggregation member ports.
If the system fails to apply the configuration to the aggregate interface, it stops applying the
configuration to aggregation member ports.
If the system fails to apply the configuration to an aggregation member port, it skips the port and
moves to the next member port.
Before you use this command, make the following configurations:
Create a VLAN and associate it with specified protocols.
Configure the link type as hybrid.
Configure the port to allow the protocol-based VLAN to pass through.
Related commands: display protocol-vlan interface.
Examples
# Associate the hybrid port Ethernet 1/0/1 with protocol 0 (IPv4) in VLAN 2.
<Sysname> system-view
[Sysname] vlan 2
[Sysname-vlan2] protocol-vlan ipv4
[Sysname-vlan2] quit
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] port link-type hybrid
[Sysname-Ethernet1/0/1] port hybrid vlan 2 untagged
Please wait... Done
[Sysname-Ethernet1/0/1] port hybrid protocol-vlan vlan 2 0
# Associate the hybrid Layer 2 aggregate interface Bridge-Aggregation 1 with protocol 0 in VLAN 2.
<Sysname> system-view
[Sysname] vlan 2
[Sysname-vlan2] protocol-vlan ipv4
[Sysname-vlan2] quit
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] port link-type hybrid
[Sysname-Bridge-Aggregation1] port hybrid vlan 2 untagged
Please wait... Done
Configuring Ethernet1/0/1... Done.
Configuring Ethernet1/0/2... Done.
Configuring Ethernet1/0/3... Done.
[Sysname-Bridge-Aggregation1] port hybrid protocol-vlan vlan 2 0
The output shows that Ethernet 1/0/1, Ethernet 1/0/2, and Ethernet 1/0/3 are the member ports of the
aggregation group corresponding to Bridge-Aggregation 1.

protocol-vlan

Syntax
protocol-vlan [ protocol-index ] { at | ipv4 | ipv6 | ipx ethernetii | mode { ethernetii etype etype-id
| snap etype etype-id } }
undo protocol-vlan { protocol-index [ to protocol-end ] | all }
View
VLAN view
159

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents