Check Region-Configuration - HP 3100 v2 Series Command Reference Manual

Description
Use bpdu-drop any to enable BPDU drop on a port.
Use undo bpdu-drop any to disable BPDU drop on a port.
By default, BPDU drop is disabled on a port.
Examples
# Enable BPDU drop on port Ethernet 1/0/1.
<Sysname> system-view
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] bpdu-drop any

check region-configuration

Syntax
check region-configuration
View
MST region view
Default level
2: System level
Parameters
None
Description
Use check region-configuration to display MST region pre-configuration information, including the
region name, revision level, and VLAN-to-instance mapping settings.
Two or more spanning tree devices belong to the same MST region only if they are configured with
the same format selector (0 by default, not configurable), MST region name, MST region revision
level, and the same VLAN-to-instance mapping entries in the MST region, and if they are connected
via a physical link.
Hewlett Packard Enterprise recommends that you use this command to determine whether the MST
region configurations to be activated are correct. Activate them only when they are correct.
Related commands: instance, region-name, revision-level, vlan-mapping modulo, and active
region-configuration.
Examples
# Display MST region pre-configurations.
<Sysname> system-view
[Sysname] stp region-configuration
[Sysname-mst-region] check region-configuration
Admin Configuration
Format selector
Region name
Revision level
Configuration digest :0x41b5018aca57daa8dcfdba2984d99d06
Instance
0
:0
:000fe26a58ed
:0
Vlans Mapped
1 to 9, 11 to 4094
86