HP 3100 v2 Series Command Reference Manual page 219

med-tlv: Advertises LLDP-MED TLVs.
capability: Advertises LLDP-MED capabilities TLVs.
inventory: Advertises the following TLVs: hardware revision, firmware revision, software revision,
serial number, manufacturer name, model name, and asset ID.
location-id: Advertises location identification TLVs.
civic-address: Inserts the normal address information about the network device in location
identification TLVs .
device-type: Sets a device type value, in the range of 0 to 2.
•
Value 0 specifies a DHCP server.
•
Value 1 specifies a switch.
•
Value 2 specifies an LLDP-MED endpoint.
country-code: Sets a country code, corresponding to ISO 3166.
{ ca-type ca-value }&<1-10>: Configures address information, where ca-type represents the address
information type, in the range of 0 to 255, ca-value represents address information, a string of 1 to
250 characters, and &<1-10> indicates that you can enter up to 10 parameters.
elin-address: Inserts telephone numbers for emergencies in location identification TLVs.
tel-number: Sets the telephone number for emergencies, a string of 10 to 25 characters.
network-policy: Advertises network policy TLVs.
power-over-ethernet: Advertises extended power-via-MDI TLVs.
Description
Use lldp tlv-enable to configure the types of advertisable TLVs for a port or all ports in a port group.
Use undo lldp tlv-enable to disable the advertising of specific types of TLVs.
By default, the device can advertise on a Layer 2 Ethernet port all types of LLDP TLVs, except
location identification TLVs.
To enable the device to advertise LLDP-MED TLVs, you must first enable it to advertise LLDP-MED
capabilities TLVs.
To disable the device from advertising LLDP-MED capabilities TLVs, you must first disable it from
advertising other LLDP-MED TLVs.
To disable the device from advertising MAC/PHY configuration/status TLVs, you must first disable it
from advertising LLDP-MED capabilities TLVs.
If you enable the device to advertise LLDP-MED capabilities TLVs, you also enable it to advertise
MAC/PHY configuration/status TLVs.
To enable the device to advertise multiple types of TLVs, you can execute the lldp tlv-enable
command repeatedly without the all keyword specified.
Examples
# Enable the device to advertise link aggregation TLVs of the IEEE 802.3 organizationally specific
TLVs on Ethernet 1/0/1.
<Sysname> system-view
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] lldp tlv-enable dot3-tlv link-aggregation
ce vlan track lldp
212