Qinq Enable Downlink; Remark Customer-Vlan-Id - HP 3100 v2 Series Command Reference Manual

VLAN mapping configuration commands
(available only on the HPE 3100 v2 EI)
VLAN mapping is achieved mainly through QoS policies. This chapter introduces part of the
commands for ports involved in many-to-one VLAN mapping. For QoS policy configuration
commands, see ACL and QoS Command Reference.

qinq enable downlink

Syntax
qinq enable downlink
undo qinq enable
View
Layer 2 Ethernet interface view, port group view
Default level
2: System level
Parameters
None
Description
Use qinq enable downlink to enable selective QinQ on an Ethernet port or a group of Ethernet
ports.
Use undo qinq enable to disable selective QinQ on an Ethernet port or a group of Ethernet ports.
By default, selective QinQ is disabled on Ethernet ports.
Configured in Layer 2 Ethernet interface view, the command takes effect only on the interface.
Configured in port group view, the command takes effect on all ports in the group.
Examples
# Enable selective QinQ on port Ethernet 1/0/1.
<Sysname> system-view
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] qinq enable downlink
# Enable selective QinQ on port group 1.
<Sysname> system-view
[Sysname] port-group manual 1
[Sysname-port-group-manual-1] group-member ethernet 1/0/1 to ethernet 1/0/6
[Sysname-port-group-manual-1] qinq enable downlink

remark customer-vlan-id

Syntax
remark customer-vlan-id vlan-id
undo remark customer-vlan-id
186