Table of Contents
Advertisement
General Information
Model 11713A
DESCRIPTION (Cont'd)
front panel status monitoring, and a self-contained
power- supply with current limiting. The Driver is
designed to provide in a single enclosure a conven¬
ient interface control unit.
OPTIONS
Option 907, Front Handle Kit. This kit contains
front panel handles that can be added to the Driver
cabinet (Figure 1-1). Order HP Part No. 5061-9688-
Option 908, Rack Adapter Kit. This kit contains
the flange and hardware for mounting the Driver in
a standard rack of 48.3 cm (19 inches). Order HP
Part No. 5061-9672 Rack Adapter Kit Half Module
(Figure 1-1).
ACCESSORIES SUPPLIED
The accessories supplied with the Driver are shown
in Figure 1-1. The power cable is selected at the
factory_ according _tp the yoitag_e availabU in_ the
country of destination.
EQUIPMENT AVAILABLE
_Accessories-.-and-.eqmpmi^t-..may...,b.fi.,..Qld6J:fijL.fiI..
information about them may be obtained by con¬
tacting your nearest Hewlett-Packard office. Refer
to the HP model number.
Precision Microwave Coaxial Attenuators. The HP
Models 8494, 8495, and 8496 Programmable Step
Attenuators provide for control of microwave sig¬
nal levels. The HP Models 33320, 33321, and
33322 are equivalent versions of the above attenu¬
ators for OEM applications.
Microwave Coaxial Switches. The HP Model 8761B
SPOT RF Switch and 33311B/C Coaxial Switches
provide switchable microwave signal paths, with
the ungated ports terminated in 50 ohms.
To connect two of the programmable step attenua¬
tors in series use HP 11716A (Type N connectors)
or HP 11716B (APC-7® connectors) Intercon¬
nection Kit.
To rack mount attenuators or RF
switches use HP 11717A Attenuator/Switch Rack
Mount Support Kit. If the Driver is to be used on
the bench in a position that requires setting it on
the rear panel a kit is available that includes feet
with mounting screws. Order HP part number
506Y-0095.- ■■ ■■ ■ ■'' ■.. " " " " ■ ^
^
■
RECOMMENDED TEST EQUIPMENT
T.est,.fiqujpment required to maintain the .Diiv.er_is..
listed in Table 1-3. Equipment other than the
recommended models can be used provided the
minimum specifications are satisfied.
Table 1-1. Specifications
Operating Temperature: 0 to
Driver Power Supply Capability:
Voltage: +24±2.0Vdc.
Current:
1.3A maximum peak for
1
second.
0.65A maximum continuous current.
Contact pairs 1 through 8, 9, and 0, maximum current of 0.65A;
continuous through one or all contacts.
®R egistered trademark of the Bunker Rarao Corporati on
1-2
Advertisement
Table of Contents
