Setup Procedure - Ricoh 3406WD Setting Manual

• Before using this machine with a wireless LAN interface, you must select [Wireless LAN] in [LAN Type].
• p.31 "Interface Settings"

Setup Procedure

This section describes how to setup wireless LAN interface.
To configure the wireless LAN settings: open [System Settings], [Interface Settings], select [Wireless LAN],
and then use the following procedure.
Select the communication mode
802.11 Ad-hoc Mode
Set the SSID
Select ad-hoc channel
Select Security Type
Enable/Disable Encryption (WEP/WPA)
Confirm the connection
• Select [802.11 Ad-hoc Mode] when connecting Windows XP as a wireless LAN client using Windows
XP standard driver or utilities, or when not using the infrastructure mode.
• When [802.11 Ad-hoc Mode] is selected in Communication Mode, select the channel for [Ad-hoc
Channel]. Set a channel that matches the type of wireless LAN being used. For details about setting
the Ad-hoc Channel, see "Interface Settings ".
• You can specify either "WEP" or "WPA" to the Security Method.
• Specify "WPA", when [Communication Mode] is set to [Infrastructure Mode].
• If you select the [WPA] option for Security Method, select one of the following: [WPA-PSK], [WPA],
[WPA2-PSK], or [WPA2]. If you select [WPA-PSK] or [WPA2-PSK], enter your PSK. If you select
[WPA] or [WPA2], authentication settings and certificate installation settings are required. For details
about setting methods, see "Configuring IEEE 802.1X".
Connecting to the Interface
Select the communication mode
Infrastructure Mode
Set the SSID
Select Security Type
Enable/Disable Encryption (WEP/WPA)
Confirm the connection
2
BZU020
71