Ricoh 3406WD Setting Manual page 24

1. System Settings
Default for Vertical: [0.0%] / Horizontal: [0.0%].
Specify the ratio between -1.0% and 1.0% (in 0.1% increments)
To set the Fine Ratio setting, measure the length of the original and the copy image to calculate the
1
ratio.
Fine Ratio Adjustment: Printer
Specify the fine ratio when the optional printer is installed. Depending on paper type, environment,
and humidity, copy paper can expand or shrink slightly. This means that the size of the copy and the
original do not match.
When the horizontal ratios are almost the same and there are differences between the vertical ratios,
you can specify the vertical correction ratio. You can make this setting for each paper type (plain,
translucent, film and recycled paper).
Default: [0.0%]
Specify the ratio between -1.0% and 1.0% (in 0.1% increments).
For details about how to set the fine ratio, see "Fine Ratio Adjustment: Copier".
Adjust Scan Position
You can adjust the position of the scan area.
Default: [0]
Specify the scan position between -10 and +10 (in 1 increments).
Preview Area Settings
Specify the default settings of preview area, area size, and orientation for previewing stored document
at the control panel.
22
CBB002