Wsmfp - Ricoh 3406WD Setting Manual

NBT (NetBIOS over TCP/IP) scope ID selection
You can specify the NBT scope ID.
msh> wins "interface_name" scope "ScopeID"
• The scope ID can be entered using up to 31 alphanumeric characters.
• Be sure to specify the interface.
• wlan can be specified only when the IEEE 802.11 interface is installed.
Interface name
ether
wlan

wsmfp

Use the "wsmfp" command to view and configure the WSD (Device) and WSD (Printer).
View settings
msh> wsmfp
Comment settings
msh> wsmfp comments "comment"
• If you do not specify a comment, current setting is displayed.
Location configuration
mah> wsmfp location "location"
• If you do not specify a comment, current setting is displayed.
Presentation URL configuration
msh> wsmfp url "URL"
• Enter the URL string in the "URL".
WSD (Device) TCP port configuration
msh> wsmfp devport "port_number"
• The Default is 53000.
WSD (Printer) TCP port configuration
msh> wsmfp prnport "port_number"
• The Default is 53001.
WSD (Printer) timeout configuration
msh> wsmfp prntimeout [30-65535]
Remote Maintenance Using telnet
Interface configured
Ethernet interface
IEEE 802.11 interface
4
169