Ospfv3 Peer - HP 5920 Series Command Reference Manual

For PPP, LAPB, HDLC, and POS, the default network type is P2P.
•
Views
Interface view
Predefined user roles
network-admin
Parameters
broadcast: Specifies the network type as broadcast.
nbma: Specifies the network type as NBMA.
p2mp: Specifies the network type as P2MP.
unicast: Specifies the P2MP interface to unicast OSPFv3 packets. By default, a P2MP interface multicasts
OSPFv3 packets.
p2p: Specifies the network type as P2P.
instance-id: Specifies the instance ID of an interface, in the range of 0 to 255. The default is 0.
Usage guidelines
If a router on a broadcast network does not support multicast, configure the network type for the
connected interfaces as NBMA.
If any two routers on an NBMA network are directly connected through a virtual link, the network is fully
meshed. You can configure the network type for the connected interfaces as NBMA. If two routers are not
directly connected, configure the P2MP network type so that the two routers can exchange routing
information through another router.
When the network type of an interface is NBMA or P2MP unicast, you must use the peer command to
specify the neighbor.
When the network type of an interface is P2MP unicast, all OSPFv3 packets are unicast by the interface.
Examples
# Configure the OSPFv3 network type for VLAN-interface 20 as NBMA.
<Sysname> system-view
[Sysname] interface vlan-interface 20
[Sysname-Vlan-interface20] ospfv3 network-type nbma
Related commands
ospfv3 dr-priority

ospfv3 peer

Use ospfv3 peer to specify a neighbor and the DR priority of the neighbor.
Use undo ospfv3 peer to remove the configuration.
Syntax
ospfv3 peer ipv6-address [ cost value | dr-priority dr-priority ] [ instance instance-id ]
undo ospfv3 peer ipv6-address [ instance instance-id ]
502