HP 5920 Series Command Reference Manual page 127

IP Address Type
192.168.1.1 PTP
Area: 0.0.0.1
IP Address Type
172.16.0.1 Broadcast
Table 32 Command output
Field
Area
IP address
Type
State
Cost
Pri
DR
BDR
# Display detailed information about VLAN-interface 1.
<Sysname> display ospf interface Vlan-interface 1
OSPF Process 1 with Router ID 192.168.1.1
Interfaces
Interface: 172.16.0.1 (Vlan-interface1)
Cost: 1 State: DR
Priority: 1
Designated router: 172.16.0.1
Backup designated router: 0.0.0.0
Timers: Hello 10, Dead 40, Poll
FRR backup: Enabled
Enabled by interface configuration (including secondary IP addresses)
MD5 authentication enabled.
The last key is 3.
State Cost
P-2-P 1562
State Cost
DR 1
Description
Area ID of the interface.
Interface IP address (regardless of whether TE is enabled or not).
Interface network type: PTP, PTMP, Broadcast, or NBMA.
Interface state:
•
DOWN—No protocol traffic can be sent or received on the interface.
•
Loopback—The interface is in loopback state and it cannot forward traffic.
•
Waiting—The interface starts sending and receiving Hello packets and the
router is trying to determine the identity of the (Backup) designated router for
the network.
•
P-2-P—The interface will send Hello packets at the interval of HelloInterval,
and try to establish an adjacency with the neighbor.
•
DR—The router is the designated router on the network.
•
BDR—The router is the backup designated router on the network.
•
DROther—The router is a DROther router on the attached network.
Interface cost.
Router priority.
DR on the interface's network segment.
BDR on the interface's network segment.
Type: Broadcast
40, Retransmit 5, Transmit Delay 1
114
Pri DR
1 0.0.0.0
Pri DR
1 172.16.0.1
MTU: 1500
BDR
0.0.0.0
BDR
0.0.0.0