Asbr-Summary (Ospfv3 View) - HP 5920 Series Command Reference Manual

Syntax
area area-id
undo area area-id
Default
No OSPFv3 area is created.
Views
OSPFv3 view
Predefined user roles
network-admin
Parameters
area-id: Specifies an area by its ID, an IPv4 address or a decimal integer in the range of 0 to
4294967295 that is changed to an IPv4 address by the system.
Examples
# Create OSPFv3 area 0 and enter its view.
<Sysname> system-view
[Sysname] ospfv3 1
[Sysname-ospfv3-1] area 0
[Sysname-ospfv3-1-area-0.0.0.0]

asbr-summary (OSPFv3 view)

Use asbr-summary to configure route summarization on an ASBR.
Use undo asbr-summary to remove the configuration.
NOTE:
This command is available in Release 2311P04 and later versions.
Syntax
asbr-summary ipv6-address prefix-length [ cost cost | not-advertise | nssa-only | tag tag ] *
undo asbr-summary ipv6-address prefix-length
Default
Route summarization is not configured on an ASBR.
Views
OSPFv3 view
Predefined user roles
network-admin
Parameters
ipv6-address: Specifies the destination IPv6 address of the summary route.
prefix-length: Specifies the prefix length in the range of 0 to 128.
440