Consolidated Platform Configuration Guide, Cisco Ios Release 15.2(4)E (Catalyst 2960-X Switches - Cisco Catalyst 2960 series Configuration Manual

How to Configure SNMP
Notification Type Keyword
hsrp
ipmulticast
mac-notification
msdp
ospf
pim
port-security
rtr
snmp
storm-control
stpx
syslog
tty
vlan-membership
vlancreate
vlandelete
vtp
Follow these steps to configure the switch to send traps or informs to a host.

Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)

460
Description
Generates a trap for Hot Standby Router Protocol (HSRP) changes.
Generates a trap for IP multicast routing changes.
Generates a trap for MAC address notifications.
Generates a trap for Multicast Source Discovery Protocol (MSDP)
changes.
Generates a trap for Open Shortest Path First (OSPF) changes. You
can enable any or all of these traps: Cisco specific, errors, link-state
advertisement, rate limit, retransmit, and state changes.
Generates a trap for Protocol-Independent Multicast (PIM) changes.
You can enable any or all of these traps: invalid PIM messages,
neighbor changes, and rendezvous point (RP)-mapping changes.
Generates SNMP port security traps. You can also set a maximum
trap rate per second. The range is from 0 to 1000; the default is 0,
which means that there is no rate limit.
When you configure a trap by using the notification type
Note
port-security, configure the port security trap first, and
then configure the port security trap rate:
1 snmp-server enable traps port-security
2 snmp-server enable traps port-security trap-rate rate
Generates a trap for the SNMP Response Time Reporter (RTR).
Generates a trap for SNMP-type notifications for authentication,
cold start, warm start, link up or link down.
Generates a trap for SNMP storm-control. You can also set a
maximum trap rate per minute. The range is from 0 to 1000; the
default is 0 (no limit is imposed; a trap is sent at every occurrence).
Generates SNMP STP Extended MIB traps.
Generates SNMP syslog traps.
Generates a trap for TCP connections. This trap is enabled by default.
Generates a trap for SNMP VLAN membership changes.
Generates SNMP VLAN created traps.
Generates SNMP VLAN deleted traps.
Generates a trap for VLAN Trunking Protocol (VTP) changes.