Consolidated Platform Configuration Guide, Cisco Ios Release 15.2(4)E (Catalyst 2960-X Switches - Cisco Catalyst 2960 series Configuration Manual

How to Configure EtherChannels
SUMMARY STEPS
1. enable
2. configure terminal
3. interface { fastethernet | gigabitethernet | tengigabitethernet} slot/port
4. lacp rate { normal | fast }
5. end
6. show lacp internal
DETAILED STEPS
Command or Action
Step 1 enable
Example:
Switch> enable
Step 2 configure terminal
Example:
Switch# configure terminal
Step 3 interface { fastethernet | gigabitethernet |
tengigabitethernet} slot/port
Example:
Switch(config)# interface gigabitEthernet 2/1
Step 4 lacp rate { normal | fast }
Example:
Switch(config-if)# lacp rate fast
Step 5
end
Example:
Switch(config)# end
Step 6
show lacp internal
Example:
Switch# show lacp internal
Switch# show lacp counters

Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)

354
Purpose
Enables privileged EXEC mode. Enter your password if
prompted.
Enters global configuration mode.
Selects the interface to configure.
Configures the rate at which LACP control packets are
received by an LACP-supported interface.
To reset the timeout rate to its default, use the no lacp
rate command
Returns to privileged EXEC mode.
Verifies your configuration.