Epson Stylus Pro 4900/Epson Stylus Pro 4910
In the next step, make sure to confirm the destination of each cable.
C A U T I O N
When connecting them again, be sure to restore the original
routing.
11. Disconnect the connector from each Paper Thickness Sensor.
12. Disengage the four hooks that secure the Paper Thickness Sensor (s), and remove
the Paper Thickness Sensors from each sensor holder.
Be sure to refer to Chapter 4 "Adjustment"
A D J U S T M E N T
R E Q U I R E D
specified adjustment after replacing or removing the Paper
Thickness Sensor (s).
<Adjustment item>
Paper Thickness Sensor Position Adjustment
- Upper right -
Paper Thickness Sensor1, 2
Connector
Hooks
Figure 3-115. Removing the Paper Thickness Sensors
DISASSEMBLY & ASSEMBLY
(see p277)
and perform
Connector
Hooks
Sensor holders
Disassembly and Assembly Procedure
Revision A
196
Confidential