Color Measurement Device Parts; Main-C Board - Epson Stylus Pro 4910 Service Manual

Epson Stylus Pro 4900/Epson Stylus Pro 4910

3.4.12 Color Measurement Device Parts

3.4.12.1 Main-C Board

1. Remove the Color Measurement Device.
2. Remove the Mounter. (p132)
3. Remove the Upper Cover. (p257)
4. Remove the I/F Cover. (p258)
5. Remove the Left Cover. (p260)
6. Release the harness from the clamps on the plate.
When removing the clamps from the plate in the next step, make
C A U T I O N
sure not to break them.
7. Remove the clamps shown in the figure from the plate.
Make sure to route the harness correctly as shown in
In the next step, make sure to confirm which screw is attached to
C H E C K
P O I N T which location because various screws are used here.
8. Remove the five screws that secure the plate.
A) Silver, Phillips, Bind machine screw M3x6: three pieces
B) Silver, Phillips, Bind machine screw M3x8 (bit: No.1): one piece
C) Silver, Phillips, Bind machine screw M2.5x4 (bit: No.1): one piece
DISASSEMBLY & ASSEMBLY
(p255)
Figure 3-206.
Disassembly and Assembly Procedure
If the FFC prevents removing the plate, disconnect the FFC from
C H E C K
the Main-C Board.
P O I N T
9. Remove the plate.
Clamp
Step 7
A
B
C
Figure 3-206. Removing the plate
Revision A
A
Clamp
A
FFC
Plate
264
Confidential