Recommended Tools - Epson Stylus Pro 4910 Service Manual

Epson Stylus Pro 4900/Epson Stylus Pro 4910

3.1.4 Recommended Tools

To protect this product from damage, use the tools indicated in the following table.
For the tools required to perform the adjustment, refer to "Tools/Consumables for
Adjustments" in Chapter 4.
Table 3-1. Tools
Name Description
4 cm or longer shaft length (The
Phillips screwdriver, No. 1 one with a magnet is
recommended)
25 cm or longer shaft length (The
one with a magnet is
recommended)
Phillips screwdriver, No. 2
Stubby driver with 4 cm or shorter
shaft length (The one with a
magnet is recommended)
±
Torque driver, No2 0.39 0.05N/m can be measured.
Flat-blade screwdriver Nothing in particular
Tweezers Nothing in particular
To mark the part installation
Pencil
position
To secure the cable/harness, or for
Acetate tape the protection against the sharp
edge
To prevent staining the printer
Waste cloth
with ink during operation
DISASSEMBLY & ASSEMBLY
Target Part
Printhead
Fan of SpectroProofer
Some encoders/sensors
Parts in general
CR Motor
Some sensors
Ink Tubes
Ink Selector
Cartridge Holder
Roll Unit Connector
Main Board
Overall parts
CR Belt
PF Belt
Ink tube clamp
Parts in general (Use this tape
when it is removed or when
replacing the part)
Ink Tube
Ink Selector Assy
Cartridge Holder
Printhead
IS Unit
Overview
Revision A
103
Confidential