Atc Motor Assy; Removing The Atc Motor Assy; Removing The Motor Assy - Epson Stylus Pro 4910 Service Manual

Epson Stylus Pro 4900/Epson Stylus Pro 4910

3.4.7.3 ATC Motor Assy

1. Remove the Right Roll Cover. (p151)
2. Remove the SUB-D Board. (p164)
3. Remove the "HOLDER,ROLLER,RIGHT".
Lock Sensor" (P. 217))
4. Release the harnesses from the hooks.
5. Remove the three screws that secure the Motor Assy.
A) Silver, Phillips, Round Washer Head S-tite M3x6: three pieces
6. Remove the Motor Assy.
7. Disconnect the connector from the ATC Motor Assy.
Motor Assy
A
Hooks
A
Figure 3-149. Removing the Motor Assy
DISASSEMBLY & ASSEMBLY
(Step 3 to Step 8 in "3.4.7.2 Roll
A
ATC Motor Assy
Connector
Disassembly and Assembly Procedure
8. Remove the retaining ring, and remove the gear.
9. Remove the two screws that secure the ATC Motor Assy, and remove the ATC
Motor Assy.
B) Silver, Phillips, Round Washer Head S-tite M3x5: two pieces
Gear
B
Retaining ring
Figure 3-150. Removing the ATC Motor Assy
When installing the ATC Motor Assy, be careful of the installation
direction referring to
Be sure to refer to Chapter 4 "Adjustment"
A D J U S T M E N T
R E Q U I R E D
specified adjustment after replacing the ATC Motor Assy.
<Adjustment item>
Counter Reset (ATC Motor Counter)
Revision A
B
ATC Motor Assy
Figure 3-149.
(see p277) and perform
Confidential
219