Table of Contents
Advertisement
30 November, 1999
Communication Switch 06
No
FUNCTION
3
Dialing requirements:
Denmark
0: Disabled 1: Enabled
4
Dialing requirements: France
0: Disabled 1: Enabled
5
Dialing requirements:
Switzerland
0: Disabled 1: Enabled
6-7 Not used
Communication Switch 07 - Not used (do not change any of these settings)
Communication Switch 08 - Not used (do not change any of these settings)
Communication Switch 09 - Not used (do not change any of these settings)
Communication Switch 0A
No
FUNCTION
0
Memory transmission
resumption point for redialing
0: From the error page
1: From page 1
1-6 Not used
7
Emergency calls using 999
0: Enabled 1: Disabled
Communication Switch 0B - Not used (do not change any of these settings)
Communication Switch 0C - Not used (do not change any of these settings)
Communication Switch 0D
No
FUNCTION
0
The available memory
to
threshold, below which ringing
7
detection (and therefore
reception into memory) is
disabled
COMMENTS
This function automatically sets these switches
to the required settings for each country after a
country code (System Switch 0F) is
programmed.
Do not change these settings.
COMMENTS
0: The transmission begins from the page where
transmission failed the previous time.
1: Transmission begins from the first page.
Do not change these settings.
If this bit is at 1, the machine will not allow you
to dial 999 at the auto-dialer.
COMMENTS
00 to FF (Hex), unit = 2 KB
(e.g. 0C(H) = 24 KB)
One page is about 24 KB.
The machine refers to this setting before each
fax reception. If the remaining memory is below
this threshold, the machine cannot receive fax
messages.
If this setting remains at 0, the machine will
detect ringing signals and enter receive mode
even if there is no available memory. This will
result in communication failure.
4-27
BIT SWITCHES
Advertisement
Table of Contents
