Ricoh FAX2000L Service Manual page 108

30 November, 1999
Address
807F49 Country dial wait interval (high)
807F4A Time between opening or closing
the Ds relay and opening the Di
relay
807F4B Break time for pulse dialing
807F4C Make time for pulse dialing
807F4D Time between final Di relay closure
and Ds relay opening or closing
807F4E Minimum pause between dialed
digits (pulse dial mode)
807F4F Time waited when a pause is
entered at the operation panel
807F50 DTMF tone on time
807F51 DTMF tone off time
Tone attenuation level of DTMF
807F52
signals while dialing
(high frequency group)
807F53 Tone attenuation value difference
between high frequency tone and
low frequency tone in DTMF
signals
807F54 PSTN: DTMF tone attenuation level
after dialing
(high frequency group)
807F55 Not used
to
807F58
807F59 Grounding time (ground start
mode)
807F5A Break time (flash start mode)
807F5B International dial access code
807F5C
807F5D PSTN access pause time
Function
4-41
NCU PARAMETERS
Unit Remarks
20 ms
1 ms See Notes 4 and 7.
Function 08 (parameter
11).
1 ms See Note 4. Function 08
(parameter 12).
1 ms See Note 4. Function 08
(parameter 13).
1 ms See Notes 4 and 7.
Function 08 (parameter
14).
20 ms See Note 4. Function 08
(parameter 15).
Function 08 (parameter
16). See Note 4.
1 ms Function 08 (parameter
17).
Function 08 (parameter
18).
-dBm x Function 08 (parameter
0.5 19). See Note 6.
-Nx0.5 Function 08 (parameter
(dB) 20). See Note 6.
-dBm x Function 08 (parameter
0.5 21). See Note 6.
Do not change these
settings.
20 ms The Gs relay remains
closed for this interval.
1 ms The OHDI relay is open for
this interval.
BCD For a code of 100:
807F5B - F1
807F5C - 00
20 ms It waits this amount of time
for each pause input after
the PSTN access code. Up
to 7 of these can be input.
If this address contains
FF[H], the pause time
stored in address 807F4F
is used.