Table of Contents
Advertisement
BIT SWITCHES
System Switch 02
No
FUNCTION
0
Memory file transfer
0: Disabled
1: Enabled
1-2 Not used
3
Substitute reception file
printout
0: Full size only
1: Reduce to the paper size
4-5 Not used
6
Memory read/write by RDS
Bit 7
6
7
0
0
0
1
1
0
1
1
System Switch 03
No
FUNCTION
0
Length of time that RDS is
to
temporarily switched on when
7
bits 6 and 7 of System Switch
02 are set to "User selectable"
System Switch 04
No
FUNCTION
0-2 Not used
3
Dedicated transmission
parameter programming
0: Disabled 1: Enabled
4
Inclusion of the Start key in
Keystroke Programs
0: Not needed 1: Needed
5
Not used
6
CSI programming level
0: User level 1: Service level
7
Telephone line type
programming mode
0: User level 1: Service level
Setting
Always disabled
User selectable
User selectable
Always enabled
COMMENTS
1: All messages in the memory (including
confidential RX messages) are sent to the fax
number, which is programmed as the service
station.
Always reset this bit to zero after transfer.
Cross-reference
Service station number programming: Function
13
Do not change these settings.
1: If the paper in the cassette is smaller than the
received message, the machine reduces the
incoming message to the paper size before
printing.
Do not change these settings.
(0,0): All RDS systems are always locked out.
(0,1), (1,0): At any time, an RDS system can
access the machine.
(1,1): At any time, an RDS system can access
the machine.
COMMENTS
00 - 99 hours (BCD).
This data is only valid if bits 6 and 7 of System
Switch 02 are set to "User selectable".
The default setting is 24 hours.
COMMENTS
Do not change these settings.
Set this bit to 1 before changing any dedicated
transmission parameters.
0: The user does not need to press the Start key
when operating a keystroke program.
Do not change the settings.
1: Only a service function can program the CSI.
1: Only a service function can program the
telephone line type selection.
4-16
30 November, 1999
Advertisement
Table of Contents
