Ricoh FAX2000L Service Manual page 190

Hide thumbs Also See for FAX2000L:
Table of Contents

Advertisement

ERROR CODES
Code
5-23
Print data error when
printing a substitute RX or
confidential RX message
5-24
Memory overflow after the
second page of a scanned
document
5-25
SAF file access error
5-30
Mode table for the first
page to be printed was not
effective
6-00
G3 ECM – T1 time out
during reception of
facsimile data
6-01
G3 ECM - no V.21 signal
was received
6-02
G3 ECM - EOR was
received
6-03
G3 ECM - non-standard
V.21 code received
6-04
G3 ECM - RTC not
detected
6-05
G3 ECM - facsimile data
frame not received within
18 seconds of CFR, but
there was no line fail
6-06
G3 ECM - coding/decoding
error
6-08
G3 ECM - PIP/PIN
received in reply to
PPS.NULL
6-09
G3 ECM - ERR received
6-10
G3 ECM - error frames still
received at the other end
after all communication
attempts at 2400 bps
Meaning
Suggested Cause/Action
Ask the other end to re-send the message.
Replace the FCU or IC memory card.
Try using a lower resolution setting.
Wait for the messages that are currently in the
memory to be sent, or delete some files from
memory.
Replace the FCU or IC memory card.
Replace the FCU or IC memory card.
Try adjusting the RX cable equalizer.
Replace the FCU or NCU.
The other terminal may be defective.
Check the line connection.
Check connections from the NCU to the FCU.
Check for a bad line or defective remote
terminal.
Replace the FCU or NCU.
Check the line connection.
Check connections from the NCU to the FCU.
Check for a bad line or defective remote
terminal.
Replace the FCU or NCU.
Try adjusting the RX cable equalizer
Cross-reference
RX cable equalizer - G3 Switch 07 (PSTN), G3
Switch 08 (PABX)
Defective FCU.
The other terminal may be defective.
The other end pressed Stop during
communication.
The other terminal may be defective.
Check for a noisy line.
Adjust the TX levels of the communicating
machines.
See code 6-05.
Check for line noise.
Adjust the TX level (use NCU parameter 01 or
the dedicated TX parameter for that address).
Check the line connection.
Defective remote terminal.
7-32
30 November, 1999

Advertisement

Table of Contents
loading

Table of Contents