Table of Contents
Advertisement
BIT SWITCHES
System Switch 12
No
FUNCTION
0
TTI printing position in the
to
main scan direction
7
System Switch 13 - Not used (do not change any of these settings)
System Switch 14 - Not used (do not change any of these settings)
System Switch 15
No
FUNCTION
0
Not used
1
Programming with European
characters
0: Disabled 1: Enabled
2-7 Not used
System Switch 16 - Not used (do not change any of these settings)
System Switch 17
No
FUNCTION
0
Not used
1
Direct fax number entry
0: Disabled 1: Enabled
2-7 Not used
System Switch 18 - Not used (do not change any of these settings)
System Switch 19 - Not used (do not change any of these settings)
System Switch 1A - Not used (do not change any of these settings)
System Switch 1B - Not used (do not change any of these settings)
System Switch 1C - Not used (do not change any of these settings)
System Switch 1D - Not used (do not change any of these settings)
System Switch 1E - Not used (do not change any of these settings)
System Switch 1F - Not used (do not change any of these settings)
COMMENTS
08 to 92 (BCD) mm. Only input even numbers.
This setting determines the TTI print start
position from the left edge of the paper. If the
TTI is too far to the right, the file number, which
is on the top right of the page, may obscure it.
COMMENTS
Do not change this setting.
1: The user can program with European
characters (e.g. "ä", "å") for the TTI, Quick Dial
labels, etc.
Do not change these settings.
COMMENTS
Do not change this setting.
0: The user must place the original on the ADF
before dialing.
Do not change these settings.
4-20
30 November, 1999
Advertisement
Table of Contents
