Table of Contents
Advertisement
BIT SWITCHES
System Switch 09
No
FUNCTION
6
Conditions for printing the
protocol dump list
0: Print for all communications
1: Print only when there is a
communication error
7
Priority given to various types
of remote terminal ID when
printing reports
0: RTI > CSI > Dial label >
Tel. Number
1: Dial label > Tel. number >
RTI > CSI
System Switch 0A
No
FUNCTION
0-3 Not used
4
Dialing on the ten-key pad
when the handset is off-hook
0: Disabled 1: Enabled
5
On-hook dial
0: Disabled 1: Enabled
6-7 Not used
System Switch 0B
No
FUNCTION
0
Automatic reset timer
Bit 1
Bit 0 Timer setting
1
0
0
0
1
1
0
1
1
2
Power Saver mode timer
Bit 3
Bit 2 Time Limit
3
0
0
0
1
1
0
1
1
4-7 Not used
1 minute
3 minutes
5 minutes
No limit
1 minute
3 minutes
5 minutes
No limit
COMMENTS
This switch becomes effective only when system
switch 00 bit 6 is set to 1.
1: Set this bit to 1 when you wish to print a
protocol dump list only for communications with
errors.
This bit determines which set of priorities the
machine uses when listing remote terminal
names on reports.
Dial Label: The name stored with the
Quick/Speed Dial number by the user.
COMMENTS
Do not change these settings.
1: The user can dial on the ten-key pad when
the handset is off-hook.
0: On-hook dial is disabled.
Do not change these settings.
COMMENTS
(1, 1): Automatic reset is disabled.
(Other): The machine returns to standby mode
when the timer expires after the last operation.
(1, 1): Automatic Power Saver mode is
disabled.
(Other): The machine goes into Power Saver
mode when the timer expires after the last
operation.
Cross-reference
Power Saver modes: Section 2.3.1
Do not change these settings.
4-18
30 November, 1999
Advertisement
Table of Contents
