Table of Contents
Advertisement
Verifying the SAN Volume Controller installation
Once the SAN Volume Controller is installed, you can verify the installation.
Check the speed at which the SAN Volume Controller nodes are to be operated
(usually 2 Gbps) in the configuration data table that is provided by the customer.
This task shows you how to verify the installation after you install the SAN Volume
Controller in the rack and connect it to both the uninterruptible power supply and
the SAN.
Perform the following steps to verify installation:
Figure 31. Front panel display when push buttons are pressed
"Ethernet option" on page 68
The Ethernet option displays the operational states of the Ethernet port.
1. Press the SAN Volume Controller power switch. Verify that the green power
light is on. If the light is not on go to MAP 5000: Start to repair the problem.
Note: You do not need to install any software. The node boots automatically.
Verify that the node is booting without error:
v If it boots without error, the Charging message is displayed in line 1 of the
front panel display. A progress bar is displayed in line 2 of the front panel
display. Battery charging can take up to 3 hours until the battery is fully
charged. When the battery is charged enough, Cluster: is displayed in line
1 of the front panel display; line 2 is blank.
2. Press and hold the select button for five seconds. The check light comes on
and a display test is performed. When the display test is complete the check
light goes off and a button test is started.
3. Press the up, down, left, and right buttons to verify that they are working.
Figure 31 shows four examples of what the front panel should display when
you press the buttons. When you have finished testing the buttons, press and
hold the select button for five seconds to exit the test.
4. If the Charging message is displayed on the front panel display, press the
select button to switch to the menu. The menu continues to be displayed while
you press the buttons on the front panel. If you do not press any buttons within
60 seconds, the menu changes to display the charging progress. You can
switch the front panel display to the menu at any time by pressing the select
button again.
Chapter 3. Installing the uninterruptible power supply and the SAN Volume Controller
No button pressed (border only)
Up button pressed
Left and Right button pressed
Select button pressed
57
Advertisement
Table of Contents
