Table of Contents
Advertisement
Figure 26. Closing the latch-lock carrier assembly
12. Push the back rail bracket
13. Push the latch lock
14. On the rear of each rail, press the blue release tab and slide the shipping
Installing the SAN Volume Controller in the rack
After installing the support rails, you are ready to install the SAN Volume Controller
in the rack.
Before you install the SAN Volume Controller in the rack, read the following caution
notice.
50
IBM TotalStorage SAN Volume Controller: Installation Guide
Important: Ensure that the locating pins are fully extended through the front
rail bracket.
2
1
1
latch-lever
2
latch-lock
the rack and align the locating pins with the rack-mounting flange.
2
(see Figure 24 on page 48) away from the rail to release
the carrier. The latch-lock carrier slides toward the rear of the rack, and the
locating pins project through the holes that are in the rear flange and in the
rear rail bracket.
Important: Ensure that the locating pins are fully extended through the rear
rail bracket.
bracket off the slide rail. Store the shipping bracket for further use.
1
(see Figure 24 on page 48) toward the rear of
Advertisement
Table of Contents
