Table of Contents
Advertisement
Installing the uninterruptible power supply 5115 in the rack
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
2. Loosen wing nuts
3. Slide the bracket toward the back of the rail.
4. Remain at the back of the rack, hold the support rail in position in the rack,
and then install and fully tighten the two mounting screws
5. Go to the front of the rack.
6. Extend the support rail toward the front of the rack.
Note: Hold the support rail in position until you have completed step 8.
7. Ensure that the support rail is horizontal. You may want to use a level to
ensure the support rail is straight.
8. Install the two mounting screws
support rail flange. Fully tighten the screws.
9. Fully tighten the two wing nuts shown as
3
10. With wing nut
still loosened, slide the bracket toward the front of the rail,
as far as it will go, with the front edge of the bracket against the back end of
the front support rail. Fully tighten the wing nut
After you have completed the preparation procedures, you are ready to install the
uninterruptible power supply (UPS) 5115 in the rack.
You must complete the following prerequisites before installing the UPS 5115 in the
rack:
v Complete the preinstallation procedures.
v Install the support rails for the UPS 5115.
v Prepare your UPS 5115 environment.
Attention:
Read all safety and environmental notices before starting the
installation process.
CAUTION:
The UPS 5115 contains its own energy source (sealed, lead-acid batteries).
The output receptacles may carry live voltage, even when the UPS 5115 is not
connected to an AC supply. (11)
CAUTION:
Do not remove or unplug the input cord when the UPS 5115 is turned on. This
removes the safety ground from the UPS 5115 and the equipment connected
to the UPS 5115. (12)
CAUTION:
To reduce the risk of fire or electric shock, install the UPS 5115 in a
temperature- and humidity-controlled indoor environment, free of conductive
contaminants. Ambient temperature must not exceed 40°C (104°F). Do not
operate near water or excessive humidity (95% maximum). (13)
Chapter 3. Installing the uninterruptible power supply and the SAN Volume Controller
3
2
and
.
1
into the third and fourth holes of the
2
5
.
in the figure.
3
.
37
Advertisement
Table of Contents
