Table of Contents
Advertisement
Attention:
Static electricity can damage electronic devices and your system. To
avoid damage, keep static-sensitive devices in their static protective bags until you
are ready to install them.
To reduce the possibility of electrostatic discharge, observe the following
precautions:
v Limit your movement. Movement can cause static electricity to build up around
you.
v Handle the device carefully, holding it by its edges or its frame.
v Do not touch solder joints, pins, or exposed printed circuitry.
v Do not leave the device where others can handle and possibly damage the
device.
v While the device is still in its anti-static bag, touch it to an unpainted metal part of
the system unit for at least 2 seconds. (This action removes static electricity from
the package and from your body.)
v Remove the device from its package and install it directly into your SAN Volume
Controller, without putting it down. If it is necessary to put the device down, place
it onto its static-protective bag. (If your device is an adapter, place it component
side up.) Do not place the device onto the cover of the SAN Volume Controller or
onto a metal table.
v Take additional care when you handle devices during cold weather because
heating reduces indoor humidity and increases static electricity.
xxvii
About this guide
Advertisement
Table of Contents
