Table of Contents
Advertisement
2-4
Attention:
To avoid damage to the computer, always remove the
controller from the PCI Express slot before you relocate or
ship the computer.
Figure 2.1
ServeRAID-MR10M Controller Installation in a
PCI Express Slot
Bracket Screw
Press Here
85021-06
Edge of
Motherboard
Step 7. Configure and Install the SAS Devices, the SATA II Devices, or
Both in the Host Computer Case
Configure the SAS devices, SATA II devices, or both, and
install them in the external enclosure.
Note:
See the documentation for the external devices for pre-
installation configuration requirements.
Step 8. Connect the SAS Devices, the SATA II Devices, or Both to the
Controller
Use SAS cables to connect SAS devices, SATA II devices, or
both to the ServeRAID-MR10M controller. Refer to
ServeRAID-MR10M SAS/SATA Controller Hardware Installation
iBBU (Top View)
Press Here
Edge of Motherboard
Section 2.4,
Advertisement
Table of Contents
