Table of Contents
Advertisement
Figure 32. Node number
E t h e r n e t :
I n a c t i v e
Figure 33. Ethernet mode
10. Keep pressing and releasing the left or right button to display the other port
11. If the configuration data table provided by the customer indicates that the SAN
12. If you want to select a language other than English, perform the following
13. Repeat steps 1 on page 56 through 12 for each SAN Volume Controller.
14. When the battery is fully charged, the charge progress bar is replaced by the
58
IBM TotalStorage SAN Volume Controller: Installation Guide
5. Keep pressing and releasing the up or down button until the Node: option is
displayed in line 1 of the front panel display.
6. Verify that the node number that is displayed in line 2 of the display is the
same as the node number that is printed on the front panel of the node (see
Figure 32).
N o d e :
x x x x x x
7. Keep pressing and releasing the up or down button until the Ethernet option is
shown on the front panel display. Line 2 of the front panel display shows the
message Inactive. This message shows that, although an Ethernet
connection is available, it cannot yet be used (see Figure 33).
8. Keep pressing and releasing the up or down button until the FC Port-1 option
shows in the display.
9. Check whether line 2 of the display shows the message Active.
options. Check whether for each port, line 2 of the display shows the message
Active. If Active is not shown for any port, go to MAP 5600: Fibre-channel to
repair the fault.
Volume Controller nodes are to be operated at 1 Gbps, press and hold the
down button; press and release the select button. Release the down button.
The second line of the display shows the current fibre channel speed setting of
the node. Press the up or down button until 1 Gbps is displayed and then
press the select button. This changes the fibre channel speed for all ports on
this node to 1 Gbps.
steps:
a. Press the up or down button until Select Language? displays.
b. Press the select button.
c. Press the left or right button until the required language is displayed.
d. Press the select button.
Cluster option on the front panel display of the SAN Volume Controller.
Advertisement
Table of Contents
