SYSTEM ADMINISTRATOR'S GUIDE
B7.2 Port Setting
To select Port Setting, follow the menu path as shown:
System Administration Top Menu - 1 - 6 - 2
Port Setting Menu
To select the Port Setting Menu for Port 1, follow the menu path as shown:
System Administration Top Menu - 1 - 6 - 2 - 1
Parameter
Flash Time
CPC Signal
Disconnect
Time
Dial Mode
Note
The port assignment procedure for Port 2 is the same as Port 1.
244
Value Range
(Default)
1. 100 ms
Specifies the duration of the flash (recall) signal that the
VPS will send to the PBX.
(100)
1. None
Specifies the minimum time necessary to detect an
2. 6.5 ms
interruption in the CPC (Calling Party Control) signal
3. 150 ms
received from the PBX. The VPS is able to determine
4. 300 ms
that the line has been disconnected when an
5. 450 ms
interruption of the CPC signal has been detected.
6. 600 ms
(6.5)
1-8 s
Specifies the length of time the line is temporarily
unavailable after a call has ended.
(2)
1. DTMF
Specifies the dial mode for DTMF (touchtone) or Pulse.
2. Pulse 10 pps
If Pulse is specified, pulse speed (10/20 pps) must be
3. Pulse 20 pps
selected.
(DTMF)
Note: This setting only affects outward dialling from
the VPS. The VPS can only receive DTMF (touchtone)
signals.
Table 69
Description/Function
Installation Manual