Wait For Caller Id (Wcid) - Panasonic KX-TVP50E Installation Manual

To change the mode from "PUTD" to "OFF," Type PUTD again.
$ PUTD
Target Port : 00
Don't leave enabled after troubleshooting
$
Note: "*" means "enable" for the port
To set the mode for only 1 port, Type PUTD and the port number.
$ PUTD 1
Target Port : 0*
Don't leave enabled after troubleshooting.
$
Sample display:
$ PUTD
Don't leave enabled after troubleshooting
$
[1] DTMF:3
[1] DTMF:8
[1] A.Attend
[1] DTMF:#
[1] DTMF:6
[1] Voice Mail
[1] DTMF:1
[1] DTMF:0
[1] DTMF:1
[1] NonSub Svc
[1] * * *
[1] DTMF:#
[1] DTMF:9
[1] Thank you
WARNING
"PUTD" is a command originally used when troubleshooting. Do not use this command
for any other purpose. Do not disconnect the RS-232C connection while the "PUTD"
command is enabled. This could cause data overflow.

7.2.20 Wait for Caller ID (WCID)

Use the WCID command to specify the length of time (in seconds) the VPS must wait for the
Caller ID after the VPS has received the incoming call from the PBX.
Installation Manual
"0" means "disable" for the port
Target Port for Debug : * *
SYSTEM MAINTENANCE AND TROUBLESHOOTING
133