Panasonic KX-TVP50E Installation Manual page 239

Parameter
Intercom
Paging
Sequence
Release for
Intercom
Paging
No Answer
Time for
Intercom
Paging
Announcement
Repeat Cycle
Intercom
Paging Retry
Installation Manual
Value Range
(Default)
Up to 12 digits con- Specifies the intercom paging sequence required by
the PBX. It can be programmed using up to 12 of the
sisting of 0-9, , #
following 8 letters and 12 dial codes.
and special codes
(FXW)
D: Disconnecting
F: Flash (Recall)
R: Ringback Tone Detection
S: Silence Detection
T: Dial Tone Detection
W: Wait for 1 s
X: Pager Dialling
A: Answer
1-9, 0, , #: Dial Digits
Up to 12 digits con- Specifies the intercom paging release code required by
the PBX. It can be programmed using up to 12 of the 8
sisting of 0-9, , #
letters and 12 dial digits as specified above.
and special codes
(F)
1-30 s When there is no answer, this parameter specifies the
(5) length of time (in seconds) the VPS must wait before
concluding Intercom Paging.
The VPS will return to the caller if the paged party
does not respond before this timer expires.
1-3 times Specifies the number of times the intercom page will
be announced.
(1)
Example:
"I have a call for (mailbox owner's name)."
1-10 times Specifies the number of times paging will be retried
(2) when the paging destination is busy or if there is no
answer.
Note: This setting applies when the subscriber has set
only "Intercom Paging" status to enable in Incomplete
Call Handling Status.
SYSTEM ADMINISTRATOR'S GUIDE
Table 65
Description/Function
239