Panasonic KX-TVP50E Installation Manual page 147

PROBLEM
Unable to access to Operator 1 • Improper setting of the
Connected terminal (RS-232C
port) does not operate.
Unable to make reconnection
when the line is busy.
Unable to make a no-response
reconnection.
Unable to generate a call
waiting tone from the VPS.
Unable to make an Intercom
Paging for groups.
Installation Manual
Table 30
PROBABLE CAUSE
operator extension number.
• Improper connection.
• Improper setting of the
parameter.
• Improper setting of the busy
signal reconnection procedure.
• Improper setting of the no-
response reconnection
procedure.
• Improper setting of sequence. • Adjust the Call Waiting
• Improper setting of the
Intercom Paging access code.
SYSTEM MAINTENANCE AND TROUBLESHOOTING
POSSIBLE SOLUTION
• Adjust the operator extension
number to that of the connected
PBX (see "Operator's
Extension" in Table 43 in
B5.1 Automated Attendant
Parameters).
• Be sure you are using a null
modem cable (see
2.8 TERMINAL
CONNECTION).
• The terminal and VPS should
have the same parameter
settings for Baud Rate, Word
Bit Length, Parity and Stop Bit
Length (see B7.1 RS-232C
Parameters).
• Re-adjust the busy signal
reconnection procedure to that
of the connected PBX (see
"Reconnect Sequence on Busy"
in Table 72 in B7.3 PBX
Interface Parameters).
• Re-adjust the no-response
reconnection procedure to that
of the connected PBX (see
"Reconnect Sequence on No
Answer" in Table 72 in
B7.3 PBX Interface
Parameters).
sequence to that of the
connected PBX (see "Call
Waiting Sequence" in Table 72
in B7.3 PBX Interface
Parameters).
• Adjust the Intercom Paging
access code to that of the
connected PBX (see "Paging
Code for Group 1-8" and
"Paging Code for All Groups"
in Table 64 in B6.7 Other
Parameters).
147