12
WHEELS
12.4.3
Removing the brake disc of the front brake
12.4.4
Installing the brake disc of the front brake
Main work
–
Check the wheel bearing for damage and wear.
»
If the wheel bearing is damaged or worn:
–
Change the wheel bearing.
–
Clean and grease the shaft seal rings
Long-life grease (
–
Insert the spacers.
–
Clean the thread of the wheel spindle and screw
–
Position the front wheel and insert the wheel spindle.
The brake linings are correctly positioned.
–
Mount and tighten screw
Guideline
Screw, front wheel spindle
–
Operate the hand brake lever repeatedly until the brake linings are in contact with
the brake disc and there is a pressure point.
–
Take the motorcycle off of the front wheel stand. (
B00744-10
–
Pull the front wheel brake and push down hard on the fork several times to align
the fork legs.
–
Tighten screws
Guideline
Screw, fork stub
Finishing work
–
Take the motorcycle off of the rear wheel stand. (
Preparatory work
–
Raise the motorcycle with the rear wheel stand. (
–
Raise the motorcycle with the front wheel stand. (
–
Remove the front wheel. (
Main work
–
Remove screws
–
Remove the brake disc.
304806-10
Main work
–
Clean the contact surface of the brake disc.
–
Position the brake disc with the label facing outward.
–
Mount and tighten screws
Guideline
Screw, front brake disc
304806-10
Finishing work
–
Install the front wheel. (
–
Take the motorcycle off of the rear wheel stand. (
and mating surfaces
1
p. 250)
.
2
.
3
p. 54)
.
1
.
1
M8
p. 54)
of the spacers.
A
.
2
M8
30 Nm
(22.1 lbf ft)
p. 11)
M8
15 Nm
(11.1 lbf ft)
p. 10)
p. 10)
p. 10)
29 Nm
Loctite
(21.4 lbf ft)
p. 10)
55
®
243™