KTM 125 DUKE EU Repair Manual page 77

14 BRAKE SYSTEM
–
Cover the painted parts.
–
Remove screw cap
–
Draw the old brake fluid out of the brake fluid reservoir using a syringe and fill with
fresh brake fluid.
Bleed syringe (50329050000) (
Brake fluid DOT 4 / DOT 5.1 (
201529-10
–
Mount the corresponding bleeder cover
Bleeder cover (00029013000) (
–
Connect the bleeding device.
Bleeding device (00029013100) (
201530-10
–
Open shut-off valve
Info
Follow the operating instructions of the bleeding device.
–
Ensure that the filling pressure is set on pressure gauge
sure on the pressure regulator
Guideline
Filling pressure
201494-11
–
Pull off dust cap
Bleeding device (00029013100) (
–
Open bleeder screw
Info
Drain until fresh brake fluid emerges from the hose of the bleeder bottle
without bubbles.
–
Tighten the bleeder screw.
201531-10
–
Close shut-off valve
–
Open the bleeder screw again until no more brake fluid emerges.
Info
This prevents overfilling of the brake fluid reservoir.
–
Tighten the bleeder screw. Remove the hose of the bleeder bottle. Attach the dust
cap.
–
Disconnect the bleeding device. Remove the bleeder cover.
–
Stand the vehicle upright.
–
Correct the brake fluid to level
Brake fluid DOT 4 / DOT 5.1 (
–
Refit screw cap with membrane.
Info
Clean up overflowed or spilt brake fluid immediately with water.
–
Check the foot brake lever for a firm pressure point.
201532-10
with membrane.
1
p. 252)
p. 248)
from the special tool set.
2
p. 252)
p. 252)
.
3
if necessary.
B
2... 2.5 bar (29... 36 psi)
of the bleeder screw. Connect the hose of the bleeder bottle.
4
p. 252)
by approximately one half turn.
5
.
3
.
A
p. 248)
75
. Correct the filling pres-
A